Connecting the Rotating Connector
Step 1 - Remove the mask swivel connector from the mask

1. Position the nasal mask so that the inside of the mask is visible.
2. Remove the plastic split washer from the Mask Swivel Connector by gently pulling on one of the split washer's tabs.
3. Remove the Mask Swivel Connector.

1. Bend both tabs of the enclosed split washer slightly forward (approximately 45 degrees)
2. Insert the grooved end of the rotating connector through the opening in the front of the mask face plate. Place the split washer into the groove through the inside of the mask.
3. After the split washer is in place, gently push the tabs back against the inside of the mask face plate.
4. Pull gently on the rotating connector to ensure that the split washer is seated properly. The rotating connector should rotate freely.